Hi
Just when i thought i had nearly finished this happens
Bridge holes dont align with bridge plate.. cant believe i did it as double checked all my measurements but what can i say
Heres pics
Any suggestions ..bridge position is correct
| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Mistake made help needed please http://www-.luthiersforum.com/forum/viewtopic.php?f=10101&t=46919 |
Page 1 of 1 |
| Author: | cablepuller1 [ Mon Dec 28, 2015 6:50 am ] |
| Post subject: | Mistake made help needed please |
Hi Just when i thought i had nearly finished this happens Bridge holes dont align with bridge plate.. cant believe i did it as double checked all my measurements but what can i say Heres pics Any suggestions ..bridge position is correct
|
|
| Author: | johnparchem [ Mon Dec 28, 2015 9:53 am ] |
| Post subject: | Re: Mistake made help needed please |
I would try to fit an extension to the bridge plate. |
|
| Author: | Glen H [ Mon Dec 28, 2015 10:07 am ] |
| Post subject: | Re: Mistake made help needed please |
That's what I'd do too. Not ideal, but better than trying to remove the plate. |
|
| Author: | kencierp [ Mon Dec 28, 2015 10:14 am ] |
| Post subject: | Re: Mistake made help needed please |
Ditto on the extension -- make sure to scrape out all the glue squeeze so the extension butts well, make a clamping caul to fit, cover it with clear packaging tape to prevent gluing it to the bridge plate. Seen this before, you'll be fine. |
|
| Author: | cablepuller1 [ Mon Dec 28, 2015 12:30 pm ] |
| Post subject: | Re: Mistake made help needed please |
Ok will will go with extension plate ... thanks all for the input |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|